Installation Guide

4 Steps, 30 Minutes, Easy to setup Dingopilot in your car.

 

Step 1

Remove the rearview mirror cover trim.

 

 

Step 2

Connect harness into the car camera, and the other end connect to Panda.

 

Step 3

Place mount high and centered on the windshield.

  • Mounting prep – Clean the mounting area with the included alcohol wipe and let it dry.
  • Positioning – Ensure the top of the mount is fully visible from the driver's seat.
  • Adhere mount – Peel off the 3M tape's cover on the mount. Press firmly in the center of the mount, then the edges. Ensure no bubbles form.
  • Let the mount cure – The mount must cure for 48 hours before installing the comma device. Skipping this step will compromise the integrity of the mount.

 

Step 4

Connect type-C cable with EON and Panda for EON to get power, and reinstall the rearview mirror cover trim.

 

 Notes: The above steps are carried out on the Toyota Avalon, different brands and models of cars, may be slightly different. If you have problems in the installation process, feel free to contact our customer service!